The short answer
Liberty HVAC Services repairs gas furnaces, wall heaters, and heat pumps in Santa Monica homes, coming from our Los Angeles base about 8 miles away. We diagnose the cause first, explain your options, and help you weigh repair against replacement, including current South Coast AQMD furnace rules and the rebates offered by the utility that serves your address.
Santa Monica's winters are mild, so many furnaces and heat pumps sit idle for months and then get switched on during the first cold, damp night of the season. That's often when problems show up: a burning smell that won't fade, a blower that runs but blows cool air, or a system that won't start. Liberty HVAC Services is based in Los Angeles, about 8 miles east, and we repair heating systems in homes across Santa Monica's 90401, 90402, 90403, 90404, and 90405 ZIP codes. Our goal is to find the actual cause, explain it in plain terms, and give you repair options before any work starts.
Why Heating Systems in Santa Monica Act Up
Los Angeles has a Mediterranean climate with dry summers and mild winters, and homes near the coast stay cooler than inland valleys. In Santa Monica, that usually means the heat runs on and off for short stretches on cool mornings and evenings rather than for long cycles. A system that sits unused for most of the year collects dust on burners and sensors, and parts that have worn out quietly don't announce it until the first real call for heat.
Being close to the ocean also means damp, salty air. Over time, moisture can contribute to corrosion on outdoor heat pump coils, electrical connections, and furnace parts in garages or exterior closets. Many older Santa Monica homes and apartments also have furnaces tucked into tight hall closets, attics, or crawlspaces, or rely on gas wall heaters, so restricted airflow and clogged filters are common.
Heating Problems We Diagnose and Repair
We work on the systems most often found in Santa Monica homes: gas forced-air furnaces, gas wall and floor heaters, and electric heat pumps. Common repair calls include:
- Furnace won't ignite, or lights and then shuts off after a few seconds
- Blower runs but the air from the vents is cool or lukewarm
- Dirty or failing flame sensors and igniters
- Heat pump stuck in cooling mode or not switching to heat
- Outdoor heat pump unit icing up or running constantly
- Thermostat wiring faults or thermostats that don't call for heat
- Loud banging, squealing, or rattling from the blower or burners
- Short cycling, where the system turns on and off repeatedly
- Burning or musty smells that linger past the first few minutes of use
How a Heating Repair Visit Works
We start by asking what you've noticed and when it started. Then we check the thermostat, power, gas supply, filter, ignition sequence, burners, flame sensor, blower, and venting on a furnace, or the reversing valve, defrost controls, refrigerant circuit, and outdoor coil on a heat pump. If a safety issue such as a cracked heat exchanger or a venting problem turns up, we'll show you what we found and explain why the unit shouldn't run until it's fixed.
Before doing the repair, we walk you through what failed, what it takes to fix it, and whether there are other options. You decide how to proceed.
Repair or Replace? What Santa Monica Homeowners Should Know
If a furnace is old and needs a major part, replacement may be worth discussing. Keep in mind that South Coast AQMD Rule 1111 limits nitrogen oxide emissions from natural-gas fan-type central furnaces sold and installed in the Los Angeles region, and the district has been amending the rule toward zero-emission requirements. The district sets and revises the compliance dates, so anyone planning a furnace replacement should check the current rule first. We can talk through how it may affect your choices.
Santa Monica is a separate city from Los Angeles, and many homes outside the City of Los Angeles are served by Southern California Edison rather than LADWP. Equipment rebates depend on which utility serves your address, so we confirm the current offer before quoting it. Also note that the federal Energy Efficient Home Improvement Credit (25C) only covered qualifying heat pumps placed in service before December 31, 2025, and it is not available for new installations now.
Simple Checks Before You Call
A few quick checks can sometimes solve the problem or help us diagnose it faster:
- Make sure the thermostat is set to Heat and the set temperature is above room temperature
- Replace dead thermostat batteries
- Check for a tripped breaker and confirm the furnace power switch is on
- Replace a dirty filter
- Make sure supply vents and return grilles aren't blocked by furniture or rugs
- If you smell gas, leave the home and contact your gas utility from outside before calling us
More services in Santa Monica
- AC Repair in Santa Monica
- Heat Pump Installation in Santa Monica
- AC Installation in Santa Monica
- Furnace Repair in Santa Monica

